If this is the case, but you only have a 6-pin 12V power connector, a 6-pin one will fit but won’t provide any more than what the 6-pin provides. Unfortunately, even though a smaller cable fits, some cards simply won’t work properly without the full power provided by an 8-pin connector. To the extent permitted by applicable law, no responsibility or liability is assumed by Schneider Electric and its subsidiaries for any errors or omissions in the informational content of this material or consequences arising out of or resulting from the use of the information contained herein.Be sure to check your video card’s documentation to see if this 6-instead-of-8-pin configuration will work for you. Schneider Electric products and equipment should be installed, operated, serviced, and maintained only by qualified personnel.Īs standards, specifications, and designs change from time to time, information contained in this guide may be subject to change without notice. Schneider Electric does not grant any right or license for commercial use of the guide or its content, except for a non-exclusive and personal license to consult it on an "as is" basis.
No part of this guide may be reproduced or transmitted in any form or by any means (electronic, mechanical, photocopying, recording, or otherwise), for any purpose, without the prior written permission of Schneider Electric.
This guide and its content are protected under applicable copyright laws and furnished for informational use only. All other brands may be trademarks of their respective owners. The Schneider Electric brand and any trademarks of Schneider Electric SE and its subsidiaries referred to in this guide are the property of Schneider Electric SE or its subsidiaries. Setting up the digital input for external excitation.Switching the active communications ports for ION8650C (Feature.Disabling/enabling Ethernet ports using the front panel.Disabling/enabling COM ports using the front panel.
Power supply, auxiliary power - high voltage.Power supply, auxiliary power - low voltage.Step 10: Use phasor diagrams to verify wiring.Step 8: Configure advanced settings using ION Setup.Step 7: Set up meter using the front panel.
Step 5: Wire the communications and optional I/O.Step 4: Connect the optional auxiliary power.Grounding the meter using the meter ground lug.Grounding the meter using the socket base ground contacts.Step 1: Socket base installation and wiring.
0 kommentar(er)
